RAID Feature Support
■ Fabricated in 0.18um CMOS process with 1.8V for core and SATA PHY, and 3.3V for other I/Os.
■ Build in 128KB ROM and 64KB RAM.
■ Support 3 SATA ports to compliance with SATA 2.5 specification.
■ Support 1 USB 2.0 device port to support bulk mode data transfer.
■ Support SPI interface Flash.
■ Support General purpose I/Os.
■ Support NOR type flash for read only.
■ Support single DDR cell up to 266MHz and 1Gb.
■ Package Type: LQFP-216 PIN.
■ Compliant with Serial-ATA 2.5 specifications.
■ Support Serial-ATA Gen1i/Gen1m and Gen2i/Gen2m transfer rate of 1.5Gb/s and 3.0Gb/s.
■ Support Serial-ATA power saving mode: Partial and Slumber mode.
■ Support SATA host active LED per each channel.
■ Compliant with USB 2.0 specifications.
■ Support ATA pass through command for LBA48 and LBA28 bit data transfer.
■ Support USB high speed (480Mbps) and full speed transfer rate (12Mbps).
■ Support Mass Storage Device Class bulk only transfer.
■ Support USB vendor command (Control Endpoint) and SCSI vendor command.
■ Support USB host controller for UHCI, OHCI, EHCI mode.
■ Support RAID 0, 1, Spanning modes.
■ Support RAID 1 HDD hot-swap and auto-rebuild feature.
■ Support RAID status LED to show Critical / Fail.
■ Support LCD to display RAID and HDD status.
■ Support RAID level configuration.
■ Support GPIO setting.
Copyright © 2011 WareMax Electronics Corp., All rights reserved.